Torsional Vibration Apparatus
20 เมษายน 2566
ผู้ชม 147 ผู้ชม
DESCRIPTION
This benchtop mounted unit is used to study torsion and torsional vibration. The apparatus is constructed around a profiled aluminium base with levelling feet, onto which is mounted 4 vertical chuck pillars.
Each pillar contains a central shaft running in precision bearings with a chuck at one end which grips a torsion specimen. Each chuck also contains a large disc of varying mass and inertia. With these chucks it is possible to assemble a torsion specimen with up to 3 masses. Vibrations are transmitted into the torsion specimen by means of an exciter, which is electronically speed controlled from the main control unit.
To change the end conditions of the apparatus a fifth chuck houses a chuck which rigidly clamps the end of the torsion specimen to achieve a fixed end.
Also supplied with the apparatus is a manual torsion arrangement, which allows a known angular twist to be applied to the specimen. A cord is wrapped around one of the large discs and a load is applied via a hanger and weights set. The angle of twist for incremental loading is recorded and the modulus of rigidity can be calculated. Oscillations sensors are mounted integrally with each mass pillar and provide signals of the amplitude of vibration.
The control unit conditions these signals and makes them available to an oscilloscope (not supplied) for vibration analysis.
EXPERIMENTAL CONTENT
- Determination of the torsional stiffness of a torsion bar
- Determination of the mass moment of inertia
- Decay behaviour of torsional vibration
- Forced torsional vibration and resonance
- Torsional vibration system with three weights allowing single, two and three mass torsional vibration to be investigated
- Demonstration of the effect of frictional damping
TECHNICAL SPECIFICATIONS
- Stainless steel torsion specimen: 1300mm long x Ø6mm
- Crank offset: 0.15mm
- Up to 20Hz excitation frequency
- 20mm thick x Ø150mm inertia disc (2 off) – Steel
- 15mm thick x Ø228mm inertia disc (1 off) – Plastic
- 6 x 5N Weights
Operational conditions:
Storage temperature: -10°C to +70°C
Operating temperature range: +10°C to +50°C
Operating relative humidity range: 0 to 95%, non-condensing
FEATURES & BENEFITS
- Very visual demonstration of torsional vibration
- Fully guarded motor
- Free and fixed end conditions
- Oscillation speed digitally controlled and displayed
- Manual twist of specimen using set of weights and hanger
- Mechanical damping supplied
- Optional digital oscilloscope (INST063)
- Supplied with software