Applied Scientific Instruments Co., Ltd.

บริษัท แอพพลายด์ ไซแอนทิฟิค อินสตรูเม้นท์ส จํากัด

ศูนย์รวมเครื่องมือทดสอบ เครื่องมือวิทยาศาสตร์ เครื่องมือวิเคราะห์ทุกชนิด

 

ติดต่อสอบถาม

ผ่าน LINE ID

@asithailand

 

Series and Parallel Pumps Demonstration

หมวดหมู่สินค้า: FM SERIES - FANS AND COMPRESSORS
รหัส : FM51
Two motor-driven centrifugal pumps mounted on a stainless steel plinth with a water reservoir and pipework for continuous circulation.

02 มิถุนายน 2566

ผู้ชม 237 ผู้ชม

DESCRIPTION

Two motor-driven centrifugal pumps mounted on a stainless steel plinth with a water reservoir and pipework for continuous circulation. The pumps can be configured for single pump operation, two pumps in parallel or two pumps in series by using manually operated ball valves. Similarly, manual valves are used to control the flow and facilitate the study of suction effects, including demonstration of air release.

In parallel operation the two pumps draw from a shared inlet pipe of a wider diameter than the pump inlet, reflecting a typical industrial configuration of parallel pumping.

Each pump has impellers that can be easily accessed and replaced without tools. The FM51 is delivered with three impellers in total, one with forward curved blades and two with backward curved blades, allowing the students to investigate the effects of impeller characteristics.

Electronic sensors measure the pump outlet pressure of each pump, the shared pump inlet pressure, the flow rate and the water temperature.

The pump speed of the first pump is accurately controlled by an advanced electronic inverter within the IFD7 (an essential accessory) and can be varied over the full range.

The inverter also calculates the torque produced at the motor drive shaft, allowing the power used by the pump to be derived. The second pump runs at inherent motor speed.

This combination of control facilities allows a wide range of different configurations to be investigated.

 

DEMONSTRATION CAPABILITIES

  • Demonstration of series, parallel and single pump operations
  • Measurement of constant-speed pump performance including production of characteristic curves (one pump)
  • Comparison of head-flow characteristics with single pump operation at inherent speed
  • Investigation of impeller styles
  • Comparison of student calculations with computer results

 

TECHNICAL SPECIFICATIONS

Max flow rate: 2.2 l/s (parallel pumping, both pumps 50Hz)

Max head: 6.0m (single pump) – 12.0m (series)

Pump speed: 1,800rpm (pump 1) – 1,500rpm (pump 2)

 

 

 

ขอใบเสนอราคา

ดาวน์โหลดโบว์ชัวร์

 

 

Engine by shopup.com