Energy Losses in Pipes
18 เมษายน 2566
ผู้ชม 227 ผู้ชม
DESCRIPTION
The Energy Losses in Pipes accessory consists of a test pipe, orientated vertically on the side of the equipment, which may be fed directly from the hydraulics bench supply or, alternatively, from the integral constant head tank.
These sources provide high or low flow rates which can be controlled by a valve at the discharge end of the test pipe. Head loss between two tapping points in the test pipe is measured using two manometers, digital hand held manometer for large pressure differentials and a pressurised water manometer for small pressure differentials.
EXPERIMENTAL CONTENT
- To investigate the head loss due to friction in the flow of water through a pipe and to determine the associated friction factor over a range of flow rates in laminar flow
- To investigate the head loss due to friction in the flow of water through a pipe and to determine the associated friction factor over a range of flow rates in turbulent flow
- Determining the critical Reynolds number
TECHNICAL SPECIFICATIONS
Diameter of test pipe: 3.0mm
Length of test pipe: 760mm
Distance between pressure tapping points: 500mm
Range of digital manometer: 103 kPa
Range of water manometer: 500mm
Measuring cylinder capacity: 1000mm
